On Jan 29, 10:14 am, Ajab <jasusvi...@yahoo.com> wrote:
> Is there any way to put a copper track on ready PCBs?
> any tools or any alternatives to avoid wires/jumpers without going
There are conductive pens, and other techniques such as laying down a
metal track covered in adhesive. But these are low reliability
techniques. As you can easily see, big manufacturers who need to patch
production runs always use wire patches (typically wire-wrap wire
soldered at each end and held down across the board with glue).
Reply by Ajab●January 29, 20082008-01-29
Is there any way to put a copper track on ready PCBs?
any tools or any alternatives to avoid wires/jumpers without going
for
re-design?