EmbeddedRelated.com
Jacob Beningo
Live online course · Jacob Beningo
AI for Embedded Developers
$100 off for EmbeddedRelated readers until Dec 6 · 5 live sessions, Dec 7-11
Discount ends in
28days 01hrs 48min 41sec
Learn More →
23LCV512-I/SN

MCHP23LCV512-I/SN

Microchip Technology
SRAM - Synchronous Memory IC 512Kbit SPI - Dual I/O 20 MHz 8-SOIC
Active4,387 in stock

Overview

The 23LCV512-I/SN is a 512 Kbit Serial SRAM with a battery backup feature that allows it to behave as non-volatile memory when a small cell is connected. It supports SPI and Dual SPI (SDI) interfaces with a clock frequency up to 20 MHz, providing a high-speed volatile storage solution with unlimited endurance. The device operates across a wide voltage range of 2.5V to 5.5V, making it compatible with both 3.3V and 5V microcontrollers.

Why Choose This Part

The primary advantage is the dedicated Vbat pin, which enables easy integration of a backup battery for data retention without the wear-out concerns of EEPROM or Flash. It features zero write cycle times and a very low standby current of 4 uA, which is ideal for battery-powered applications. Additionally, its 5V tolerance and 2.5V minimum supply allow it to interface directly with a wide variety of legacy and modern logic levels.

Applications

Data Logging
Used as a high-speed buffer for sensor data before writing to slower non-volatile storage like Flash or SD cards.
Non-Volatile Parameter Storage
Utilizing the battery backup pin to maintain configuration settings and calibration data through power cycles without endurance limitations.
Audio Buffering
Provides temporary storage for audio samples in digital signal processing chains where zero write time is required.
Scratchpad Memory
Acts as an external RAM expansion for resource-constrained microcontrollers requiring additional workspace for complex calculations.

Key Specifications

Technology SRAM - Synchronous
Memory Size 512Kbit
Memory Type Volatile
Memory Format SRAM
Mounting Type Surface Mount
Package / Case 8-SOIC (0.154", 3.90mm Width)
Clock Frequency 20 MHz
Memory Interface SPI - Dual I/O
Voltage - Supply 2.5V ~ 5.5V
Memory Organization 64K x 8
Operating Temperature -40degC ~ 85degC (TA)
Supplier Device Package 8-SOIC

Getting Started

To use this device, connect it to your microcontroller via the SPI bus (MOSI, MISO, SCK, and CS) and ensure a bypass capacitor is placed near the Vcc pin. If using the battery backup feature, connect a 3V lithium coin cell or supercapacitor to the Vbat pin; otherwise, tie Vbat to ground. Microchip provides C libraries for SPI SRAM, but standard SPI drivers can be used by following the simple command set defined in the datasheet.

23LCV512-I/ Family

Comparing specs that differ across variants. The current part is highlighted.

Part Number Package Stock
23LCV512-I/SN (this part) SOIC-8 4,387
23LCV512-I/ST TSSOP-8 9,671

Also Consider

23LCV1024-I/SN MCHPMicrochip Technology - Provides double the memory capacity (1 Mbit) in the same 8-SOIC package and interface if 512 Kbit is insufficient.
23A512-I/SN MCHPMicrochip Technology - A lower-voltage alternative (1.7V to 2.2V) for ultra-low power systems that do not require 5V compatibility.