EmbeddedRelated.com
Jacob Beningo
Live online course · Jacob Beningo
AI for Embedded Developers
$100 off for EmbeddedRelated readers until Dec 6 · 5 live sessions, Dec 7-11
Discount ends in
27days 11hrs 10min 13sec
Learn More →
6N137S(TA)

6N137S(TA)

Everlight Electronics Co Ltd
Logic Output Optoisolator 10Mbps Open Collector 5000Vrms 1 Channel 5kV/µs CMTI 8-SMD
Active5,243 in stock

Overview

The 6N137S(TA) is a high-speed 10Mbps optocoupler featuring an AlGaAs LED and an integrated high-gain photodetector with an open-collector output. It provides a high isolation voltage of 5000Vrms and includes an internal Faraday shield to achieve a common mode transient immunity (CMTI) of 5kV/us. This single-channel device is designed for logic signal isolation in electrically noisy environments.

Why Choose This Part

The 6N137S(TA) offers a low propagation delay of 75ns maximum and a tight rise/fall time characteristic of 40ns and 10ns respectively. Its open-collector output allows for easy level shifting between different logic voltage rails. The 5000Vrms isolation rating ensures robust protection in industrial and mains-connected equipment.

Applications

High-Speed Digital Isolation
Ideal for isolating TTL/LSTTL and CMOS logic levels in high-speed data systems up to 10Mbps.
Industrial Communication Interfaces
Used in RS-232, RS-485, and CAN bus isolation to prevent ground loops and protect sensitive controllers from transients.
Switching Power Supply Feedback
Provides isolated feedback paths in power converters while maintaining fast transient response.
Motor Drive Control
Isolates PWM control signals from high-voltage motor power stages to ensure operator and controller safety.

Key Specifications

Data Rate 10Mbps
Input Type DC
Output Type Open Collector
Mounting Type Surface Mount
Package / Case 8-SMD, Gull Wing
Voltage - Supply 7V
Number of Channels 1
Voltage - Isolation 5000Vrms
Operating Temperature -40degC ~ 85degC
Inputs - Side 1/Side 2 1/0
Rise / Fall Time (Typ) 40ns, 10ns
Supplier Device Package 8-SMD
Current - Output / Channel 50 mA
Voltage - Forward (Vf) (Typ) 1.4V
Current - DC Forward (If) (Max) 50mA
Propagation Delay tpLH / tpHL (Max) 75ns, 75ns
Common Mode Transient Immunity (Min) 5kV/us

Getting Started

Ensure a 0.1uF bypass capacitor is placed as close as possible to the VCC and GND pins of the optoisolator to maintain high-speed switching stability. Since the output is an open collector, an external pull-up resistor (typically 330 ohms to 4k ohms depending on speed requirements) is required on the output pin. Calculate the input series resistor based on the desired LED forward current, typically 7.5mA to 10mA for reliable 10Mbps operation.