EmbeddedRelated.com
Jacob Beningo
Live online course · Jacob Beningo
AI for Embedded Developers
$100 off for EmbeddedRelated readers until Dec 6 · 5 live sessions, Dec 7-11
Discount ends in
27days 20hrs 07min 35sec
Learn More →
74HCT4051PW

74HCT4051PW

MPN: 74HCT4051PW,118
Nexperia USA Inc.
1 Circuit IC Switch 8:1 120Ohm 16-TSSOP
Active4 in stock

Overview

The 74HCT4051PW is a high-speed CMOS 8-channel analog multiplexer/demultiplexer featuring level translation. It is designed to interface 5V digital control logic with analog signals ranging up to +/-5V, providing a versatile solution for signal routing in mixed-signal systems. The device includes eight independent inputs/outputs and a common output/input, controlled by three digital select pins and an enable input.

Why Choose This Part

This device offers a high 3dB bandwidth of 180MHz and low typical ON resistance, ensuring minimal signal degradation across a wide frequency range. It features built-in 'break before make' switching to prevent momentary short circuits during channel transitions and provides high noise immunity consistent with JEDEC standards.

Applications

Analog Signal Routing
Switching multiple sensor inputs to a single ADC channel in precision measurement systems.
Digital Data Multiplexing
Consolidating eight digital lines into one stream to save microcontroller GPIO pins.
Logic Level Translation
Using the VEE pin to shift 5V logic signals to communicate with bipolar analog circuits.
Programmable Gain Amplifiers
Selecting different resistor values in a feedback loop to dynamically adjust operational amplifier gain.

Key Specifications

Mounting Type Surface Mount
-3db Bandwidth 180MHz
Package / Case 16-TSSOP (0.173", 4.40mm Width)
Number of Circuits 1
Operating Temperature -40degC ~ 125degC (TA)
Supplier Device Package 16-TSSOP
On-State Resistance (Max) 120Ohm
Switch Time (Ton, Toff) (Max) 39ns, 32ns
Voltage - Supply, Dual (V+/-) +/-1V ~ 5V
Voltage - Supply, Single (V+) 4.5V ~ 5.5V
Current - Leakage (IS(off)) (Max) 400nA
Multiplexer/Demultiplexer Circuit 8:1
Channel Capacitance (CS(off), CD(off)) 3.5pF
Channel-to-Channel Matching (ΔRon) 6Ohm

Getting Started

To use this IC, connect the VCC and GND pins to your 5V supply and ground. For bipolar signals, apply the negative rail to the VEE pin; otherwise, tie VEE to GND. Ensure the E (Enable) pin is pulled low to activate the switch, and use the S0-S2 pins to select the active channel based on the truth table in the datasheet.