EmbeddedRelated.com
Jacob Beningo
Live online course · Jacob Beningo
AI for Embedded Developers
$100 off for EmbeddedRelated readers until Dec 6 · 5 live sessions, Dec 7-11
Discount ends in
28days 13hrs 35min 18sec
Learn More →
HCPL-0201-500E

HCPL-0201-500E

Broadcom Limited
Logic Output Optoisolator 5MBd Push-Pull, Totem Pole 3750Vrms 1 Channel 1kV/µs CMTI 8-SO Tall
Active7,712 in stock

Overview

The HCPL-0201-500E is a single-channel 5MBd logic output optocoupler featuring a totem pole output stage that eliminates the need for external pull-up resistors. It provides 3750Vrms isolation and is designed to interface directly with TTL, LSTTL, and CMOS logic levels while operating over a wide supply voltage range of 4.5V to 20V.

Why Choose This Part

The integrated totem pole output simplifies BOM by removing pull-up resistors and ensures fast 5MBd switching speeds. It features built-in hysteresis for improved noise immunity and provides a high Common Mode Transient Immunity (CMTI) of 1kV/microsecond.

Applications

Isolated Line Receiver
Used in noisy industrial environments to receive digital signals without ground loops.
Microprocessor System Interfaces
Provides high-speed digital isolation between different voltage domains in embedded systems.
Computer-Peripheral Interfaces
Protects sensitive host controllers from transients and noise generated by peripheral devices.
Switching Power Supply Feedback
Transfers logic-level control signals across the primary-secondary isolation barrier.

Key Specifications

Data Rate 5MBd
Input Type DC
Output Type Push-Pull, Totem Pole
Mounting Type Surface Mount
Package / Case 8-SOIC (0.154", 3.90mm Width)
Voltage - Supply 4.5V ~ 20V
Number of Channels 1
Voltage - Isolation 3750Vrms
Operating Temperature -40degC ~ 85degC
Inputs - Side 1/Side 2 1/0
Rise / Fall Time (Typ) 30ns, 7ns
Supplier Device Package 8-SO Tall
Current - Output / Channel 25 mA
Voltage - Forward (Vf) (Typ) 1.5V
Current - DC Forward (If) (Max) 10mA
Propagation Delay tpLH / tpHL (Max) 300ns, 300ns
Common Mode Transient Immunity (Min) 1kV/us

Getting Started

Ensure a 0.1uF ceramic bypass capacitor is placed as close as possible to the Vcc and GND pins to stabilize the high-speed output stage. When designing the input circuit, calculate the series resistor to provide sufficient drive current for the LED while staying within the logic-low supply current limits of 3.7mA to 4.3mA.

Also Consider

6N137S Lite-On Inc. - A higher speed 10MBd alternative often used when faster signal transitions are required, though it requires an external pull-up resistor.
TLP2362 Toshiba - Offers 10MBd performance with a totem pole output in a smaller SO-6 package for space-constrained designs.
FOD817 ONonsemi - A much lower cost, slower phototransistor-based isolator suitable for DC or low-frequency signals where 5MBd speed is not necessary.