EmbeddedRelated.com
Jacob Beningo
Live online course · Jacob Beningo
AI for Embedded Developers
$100 off for EmbeddedRelated readers until Dec 6 · 5 live sessions, Dec 7-11
Discount ends in
22days 20hrs 39min 45sec
Learn More →
MAX3485EESA+T

ADIMAX3485EESA+T

Analog Devices Inc./Maxim Integrated
1/1 Transceiver Half RS422, RS485 8-SOIC
NRND7,447 in stock

Overview

The MAX3485EESA+T is a low-power, 12Mbps half-duplex transceiver designed for RS-485 and RS-422 communication. Operating from a 3.0V to 3.6V supply, it features enhanced ESD protection and is designed to remain interoperable with +5V logic systems. This IC is optimized for high-speed data transmission while maintaining a low shutdown current of only 2uA.

Why Choose This Part

The device offers a high 12Mbps data rate while consuming minimal power, including a 2uA shutdown mode for battery-sensitive applications. It includes internal current-limiting and thermal shutdown features to protect the driver against bus contention or short circuits. Its 3.3V operation simplifies designs by eliminating the need for 5V rails while maintaining compatibility with older 5V systems.

Applications

Industrial Control Networks
Used as the physical layer interface for programmable logic controllers (PLCs) and industrial automation equipment.
Building Automation
Facilitates communication between HVAC controllers, lighting systems, and security panels over long cable runs.
Telecommunications
Acts as a line driver and receiver for high-speed data exchange in networking backplanes and base stations.
Motor Control Feedback
Transmits high-speed encoder data from motors to central controllers in electrically noisy environments.

Key Specifications

Type Transceiver
Duplex Half
Protocol RS422, RS485
Data Rate 12Mbps
Mounting Type Surface Mount
Package / Case 8-SOIC (0.154", 3.90mm Width)
Voltage - Supply 3V ~ 3.6V
Receiver Hysteresis 50 mV
Operating Temperature -40degC ~ 85degC
Supplier Device Package 8-SOIC
Number of Drivers/Receivers 1/1

Getting Started

To implement this device, place a 0.1uF bypass capacitor as close to the VCC pin as possible and ensure the RS-485 bus is terminated with 120-ohm resistors at both ends. For development, the MAX3485 can be tested using standard USB-to-UART bridges or logic analyzers to verify the DE (Driver Enable) and RE (Receiver Enable) timing sequences.

Also Consider

THVD1429DR TITexas Instruments - Offers significantly higher ESD protection and is rated for higher 20Mbps data rates in a similar 8-SOIC footprint.
ADM3485EARZ ADIAnalog Devices Inc. - A drop-in alternative with high-speed 12Mbps performance and similar 3.3V low-power specifications.