Does P&E MULTILINK load code to EEPROM?

Started by G February 5, 2006
I use a Adapt9S12E128 board in a testing project. I am using Metrowerks 
Code Warrior - CW12V3.1. My code is working right when P&E MULTILINK 
connected with a PC. However, system will be reseted at once when 
unpluging P&E MULTILINK. Advise please. Is P&E MULTILINK able to load 
code to EEPROM?
Thanks
	
Hallo,

I use the P&E cyclone pro and not the multilink, but I think it's always the
same.
To load code in the flash and eeprom I must use two diffrent program files,
which are delivered from P&E.
The program files tells the cyclone pro, how the memory is to be program.
	regards patrick

--
Patrick Gempeler          <patrick.gempeler@patr...>
ProEda AG Datenmanagement <http://www.proeda.ch/>
Bollstr. 32, CH-3076 Worb
Tel  +41 31 838 45 00,    Fax  +41 31 838 45 40
	----- Original Message ----- 
From: "G" <yuanfen21th@yuan...>
Newsgroups: gmane.comp.hardware.microcontrollers.hc12
Sent: Sunday, February 05, 2006 5:37 PM
Subject: Does P&E MULTILINK load code to EEPROM?
	> I use a Adapt9S12E128 board in a testing project. I am using Metrowerks
> Code Warrior - CW12V3.1. My code is working right
when P&E MULTILINK
> connected with a PC. However, system will be reseted at once when
> unpluging P&E MULTILINK. Advise please. Is P&E MULTILINK able to
load
> code to EEPROM?
> Thanks
>
>
>
>
>
>
>