Hi members Try to connect LCD KS0713 controller in serial mode to my BASICX-24. (I use SID, RS, SCLK without any Pull Up resistors) ANYONE know of any BASICX-24 codes somewhere that works? Modified "LCD_595 by Jon Williams over and over" but the LCD seems to be DEAD.... Thankful for any link/s that might help. Best Regards, Hans Selin |
|
Anyone succeeded with KS0713 LCD interface ?
Started by ●March 25, 2004
Reply by ●March 25, 20042004-03-25
--- In , "gpsrunner2000" <hans.selin@g...> wrote: > Try to connect LCD KS0713 controller in serial mode to my BASICX-24. > (I use SID, RS, SCLK without any Pull Up resistors) You didn't mention the other inputs such as CS2, CS1B, RS, E_RD, RW_WR, PS and MI. Do you have them connected properly for serial input? I referred to the documentation at http://www.lcd- module.de/eng/pdf/zubehoer/ks0713.pdf. Is that what you have? |
|
Reply by ●March 26, 20042004-03-26
--- In , "Don Kinzer" <dkinzer@e...> wrote: > --- In , "gpsrunner2000" <hans.selin@g...> > wrote: > > Try to connect LCD KS0713 controller in serial mode to my BASICX- 24. > > (I use SID, RS, SCLK without any Pull Up resistors) > > You didn't mention the other inputs such as CS2, CS1B, RS, E_RD, > RW_WR, PS and MI. Do you have them connected properly for serial > input? > > I referred to the documentation at http://www.lcd- > module.de/eng/pdf/zubehoer/ks0713.pdf. Is that what you have? Yes, almost, i have KS0713B-H0CC: (www.sytco.com.tw/pdf_1/data/cog/g102064-10-3.pdf) And i have connected the following: - VDD to 3.0 Volt - VSS to ground - SID to BASICX-24 pin - SCLK to BASICX-24 pin - RS to BASICX-24 pin, High =Display Data, Low = controll Data - /RESET to BASICX-24 pin for module reset - /CS1B to BASICX-24 pin for module active or inactive Thats all, doesn't have any more connectors such as RW_WR, PS, MI, E,RD or CS2. I played with the PUTPIN, PULSOUT and Jon W's LCDPutLCD but NO data at all. /Hans |
|
Reply by ●March 26, 20042004-03-26
--- In , "gpsrunner2000" <hans.selin@g...> wrote: > I have KS0713B-H0CC: > (www.sytco.com.tw/pdf_1/data/cog/g102064-10-3.pdf) I got a 404 error trying to access that PDF. Also, I tried getting the PDF from their table of COG devices but it just kept showing the page with the table. A message to their webmaster was returned as undeliverable. Can you email me the PDF and I'll look it over to see if I can see anything that might be causing the problem. |