Forums

Wireless Comm. Module

Started by ahvah2805 April 6, 2004
Hi,

I am novice in Basix24 programming. Till now I am doing quite good.
I've bought two WCM tranceiver modules from TotalRobots. One of them
is connected to Basicx24 via I2C and the other one to PC via RS232. I
am trying to send some few bytes from Basicx24 to PC. It seems that
bytes are sent (the led on WCM is blinking) but the WCM on PC side
does not receive anything. To send the bytes I use a sample code for
I2C communication that is used for communication with compass and
ultrasonic rangers (Netmedia web site).

Have anyone some experience dealing with WCMs. May be there are some
examples.

Thank You in advance.



Hello

We have a few examples of Wireless coms with a BX24 and also with similar products.

A wireless network example: http://www.totalrobots.com/examples/example43.htm

An IRCM (Infra red control module which uses the same type of register config as the WCMs)
http://www.totalrobots.com/examples/example37.htm

See if that helps with your comms.

Make sure you have the nodes and addresse jumpers set correctly. Also with the BX24 you will need the I2C jumpers set on the WCM.

See how you get on with that.

Regards

Jamie Finnan BSc (Hons)
Total Robots Ltd
0208 823 9220

> Hi,
>
> I am novice in Basix24 programming. Till now I am doing quite good.
> I've bought two WCM tranceiver modules from TotalRobots. One of them
> is connected to Basicx24 via I2C and the other one to PC via RS232. I
> am trying to send some few bytes from Basicx24 to PC. It seems that
> bytes are sent (the led on WCM is blinking) but the WCM on PC side
> does not receive anything. To send the bytes I use a sample code for
> I2C communication that is used for communication with compass and
> ultrasonic rangers (Netmedia web site).
>
> Have anyone some experience dealing with WCMs. May be there are some
> examples.
>
> Thank You in advance. >
>
> Yahoo! Groups Links >