Forums

getting started with Cypress CY7C63310 and CY7C63801 series

Started by Gary Peek January 26, 2009
Perhaps I'm merely having a "bad documentation day", but I'm
having problems figuring out how to program the Cypress series
of chips that contains the CY7C63310 and CY7C63801.

Their datasheet says: "The enCoRe II supports in system programming
by using the D+ and D� pins as the serial programming mode interface.
The programming protocol is not USB."

This seems to imply that they have a utility program on their web
site for that purpose but I can't find it.

I see where there is a CY3655 development board but it is rather
expensive and I would prefer to avoid that.

Can anyone who has begun using this series of chips give me any
advice or tips on getting started?
Gary Peek skrev:
> Perhaps I'm merely having a "bad documentation day", but I'm > having problems figuring out how to program the Cypress series > of chips that contains the CY7C63310 and CY7C63801. > > Their datasheet says: "The enCoRe II supports in system programming > by using the D+ and D� pins as the serial programming mode interface. > The programming protocol is not USB." > > This seems to imply that they have a utility program on their web > site for that purpose but I can't find it.
If you just need the programming software, try looking for "PSoC programmer" or "PSoC Designer" or just "PSoC". http://app.cypress.com/portal/server.pt?space=CommunityPage&control=SetCommunity&CommunityID=285&PageID=552&shortlink=SD1099