Hello, I am using the omnivision evaluation board, please find the scheme here : http://img32.imageshack.us/i/ov6680sensor.pdf/ My is that i can't start the chip. What i provide to the board : Vdd : 2.8V ; GND A sin clock at 20Mhz on XCLK PWDN is pull down. The other pin are float. What happen : Nothing What i except : signal on Dato 0..7 and vsync, href and pixel clock. I don't understand my error. The chip should start to send images. Does somebody known how to start this kind of chip. Regards, J.Parent
OV6680 trouble to start.
Started by ●August 13, 2009
Reply by ●August 13, 20092009-08-13
In article <-92dnQPPXduBYh7XnZ2dnUVZ_hednZ2d@giganews.com>, jejmule@gmail.com says...> Hello, > > I am using the omnivision evaluation board, please find the scheme here : > > http://img32.imageshack.us/i/ov6680sensor.pdf/ > > My is that i can't start the chip. > > What i provide to the board : > Vdd : 2.8V ; GND > A sin clock at 20Mhz on XCLK > PWDN is pull down. > The other pin are float. > > What happen : Nothing > > What i except : signal on Dato 0..7 and vsync, href and pixel clock. > > I don't understand my error. The chip should start to send images. > Does somebody known how to start this kind of chip.I would suggest looking at the datasheet for the board, especially the Reset signal as no doubt you are one way or another holding the camera in reset mode. -- Paul Carpenter | paul@pcserviceselectronics.co.uk <http://www.pcserviceselectronics.co.uk/> PC Services <http://www.pcserviceselectronics.co.uk/fonts/> Timing Diagram Font <http://www.gnuh8.org.uk/> GNU H8 - compiler & Renesas H8/H8S/H8 Tiny <http://www.badweb.org.uk/> For those web sites you hate