IAR Workbench Kickstart to CCE V3.1

Started by manohar2008 September 10, 2009
Hi,


    Using IAR workbench Kickstart V4 IDE i wrote a code for UART
commmunication, by which i am sending some variables, this code is
perfectly working.But when i transferred the same code to CCE V3.1
Professional I am getting some junk values.


    Is it required to do any changes in the Source code or any changes in
the settings of  CCE V3.1 for Proper function of UART(not getting any junk
values)?


    Can any one suggest me what changes i have to do in IAR or CCE for
running the same code in both IDE's with out any errors?

Thanks in Advance.
Regards
Boni	   
					
---------------------------------------		
This message was sent using the comp.arch.embedded web interface on
http://www.EmbeddedRelated.com