E1 stream and spartan 3E

Hey, i want to terminate my E1 line into the spartan 3E fpga board. Can
someone tell me how will i do that. 

I am terminating E1 line into SN75183 line driver which is giving me a
differential output signal. Now i want to terminate this signal into FPGA
board, how will i do that? and if you have any other way to interface E1
and FPGA kit, kindly tell that too.


Thanks
Hassan	   
					
---------------------------------------		
Posted through http://www.EmbeddedRelated.com

Hi Hassan,

Doing same thing right now. Just terminating to ARM instead of FPGA. I
am using DS26521 transceiver from Maxim. I am sure you can make a
small dev kit with DS25621 and then interface it to FPGA. You will get
3 lines for data - serial clock, serial data and sync impulses that
will be high on frame borders. I made a deserializer from CPLD so I
get 8bit wide parallel interface instead of serial data.

I don't know your requirements, maybe LIU would be enough instead of
full transceiver. Anyway - check out maxim inventory - they have a lot
of options for TDM.

Cheers,
Justas


On Apr 10, 4:47=A0pm, "salimbaba" <ark_lightz@n_o_s_p_a_m.yahoo.com>
wrote:
> Hey, i want to terminate my E1 line into the spartan 3E fpga board. Can
> someone tell me how will i do that.
>
> I am terminating E1 line into SN75183 line driver which is giving me a
> differential output signal. Now i want to terminate this signal into FPGA
> board, how will i do that? and if you have any other way to interface E1
> and FPGA kit, kindly tell that too.
>
> Thanks
> Hassan =A0 =A0
>
> --------------------------------------- =A0 =A0 =A0 =A0
> Posted throughhttp://www.EmbeddedRelated.com