ATmega128L programming problem

Started by Daniel Hanczewski ●June 23, 2004

Dear all,

This is my first time to use ATmeg128L (3.3V version) and I'm having 
problem with programming it via SPI. I'm using STK200 with HC244 on 
board so theoreticaly this should work. But it is not. The programmer 
STK200 works fine with ATmega128 (5V version) either with PonyProg or 
WinAVR. I have also made STK200 with LCV244 but it also did not help.

Has anyone had a problem like mine?

Best regards
Daniel

Reply by Martial Chateauvieux ●June 24, 20042004-06-24

Did you notice that the Programming doesn't use MOSI/MISO but some PDI 
PDO pins ?

Martial

Daniel Hanczewski wrote:
> Dear all,
> 
> This is my first time to use ATmeg128L (3.3V version) and I'm having 
> problem with programming it via SPI. I'm using STK200 with HC244 on 
> board so theoreticaly this should work. But it is not. The programmer 
> STK200 works fine with ATmega128 (5V version) either with PonyProg or 
> WinAVR. I have also made STK200 with LCV244 but it also did not help.
> 
> Has anyone had a problem like mine?
> 
> Best regards
> Daniel
>

You might also like... (promoted content)