Hi, I have tried to make a universal IR capture for a Freescale MC9S12NE64. My gold is that the output from the controller is compatible with the Philips Pronto format ( http://home.tiscali.nl/m.majoor/prontoirformats.pdf) The program I been writing is working fine on the remote controls I have on hand. However, the problem is that when I finally think that I have made it universal, I find a new remote control that does things a different way. So now I am looking for some information on how to make I universal one for all. Any ideas? Regards Steen
Universal IR capturer
Started by ●September 20, 2006
Reply by ●September 21, 20062006-09-21
Steen Larsen wrote:> Hi, > > > > I have tried to make a universal IR capture for a Freescale MC9S12NE64. > > My gold is that the output from the controller is compatible with the > Philips Pronto format ( http://home.tiscali.nl/m.majoor/prontoirformats.pdf) > > > > The program I been writing is working fine on the remote controls I have on > hand. > > > > However, the problem is that when I finally think that I have made it > universal, I find a new remote control that does things a different way. > > > > So now I am looking for some information on how to make I universal one for > all. > > > > Any ideas? > > > > Regards > > > > SteenWell, is it at all possible to do a universal remote? how r u going to take care of the device id which is unique for each remote within the same code? I am not aware of the pronto format, u have specified above, can u just elaborate a little. And, can u also specify whats ur requirement? I mean, do u wanna write a driver supporting every protocols? I wrote a driver which could support RC5, RC6, RMAP, NEC if the carrier frequency fell in the supporting range of the decoder in the box and if the device ID's matched. Sudip