Forums

Rtos porting

Started by Non scrivetemi December 28, 2006
Anyone on here have any experience bringing up VxWorks on a 1N4148 ?





RTOS on a diode?

Non scrivetemi wrote:
> Anyone on here have any experience bringing up VxWorks on a 1N4148 ?
u.unltd@gmail.com wrote:

> RTOS on a diode?
Now _that's_ software bloat.
> > Non scrivetemi wrote: > >>Anyone on here have any experience bringing up VxWorks on a 1N4148 ? > >
Non scrivetemi wrote:
> Anyone on here have any experience bringing up VxWorks on a 1N4148 ? > > > > >
The lack of a return instruction makes this impossible. Jim
Non scrivetemi wrote:
> Anyone on here have any experience bringing up VxWorks on a 1N4148 ? >
No, but I've done a port of mewcos-II to next door's cat.
Paul Burke wrote:
> Non scrivetemi wrote: > > Anyone on here have any experience bringing up VxWorks on a 1N4148 ? > > > > No, but I've done a port of mewcos-II to next door's cat.
Very seriously speaking - you guys are funny (in the EXACT sense of the term) :) ! Have a very happy new year's eve folks! Warm regards, Rintu
"Non scrivetemi" wrote:
>Anyone on here have any experience bringing up VxWorks on a 1N4148 ?
Yes. I tried and failed miserably: If found that, due to its internal architecture, VxWorks needs at least three legs to run in a somehow stable fashion. I am currently porting it to a 2N2222A, and the project is progressing smoothly Expect a public release not later than April 1st, 2007.