SD / MMC on AT91SAM7S256

Hello NG,

i have the SAM7-P256 DEV-Board from Olimex.

But if i open and compile the mmc demo - it doesn=B4t work.
http://www.olimex.com/dev/soft/arm/SAM7/MMC.zip

Is there something i have to change after downloading it?

Thanks for any help.

Regards,
Peter

In article <1187731489.018698.193500@d55g2000hsg.googlegroups.com>, 
peter.pippinger@gmx.de says...
> Hello NG,
> 
> i have the SAM7-P256 DEV-Board from Olimex.
> 
> But if i open and compile the mmc demo - it doesn=B4t work.
> http://www.olimex.com/dev/soft/arm/SAM7/MMC.zip
> 
> Is there something i have to change after downloading it?
> 
> Thanks for any help.
> 
> Regards,
> Peter

A quick glance shows that all chip select (CS_LOW()/CS_HIGH()) commands 
are commented out in MMC.c.
It certainly will not work without a proper CS.

--Gene