Olimex USB JTAG query

	Hi, Can anyone advise me if I can use my Olimex USB
MAXQ2000 JTAG programmer to program ARM microcontrollers?.
The 10 pin connector would have to have a 20 pin adapter made
to match up the JTAG signals correctly. Internally it contains a
FTDI FT232BM, a LCX244 and a DS89C430 micro if that's any help.

tia
Mark

Hi,

Mark Harriss wrote:
> Hi, Can anyone advise me if I can use my Olimex USB
> MAXQ2000 JTAG programmer to program ARM microcontrollers?.
> The 10 pin connector would have to have a 20 pin adapter made
> to match up the JTAG signals correctly. Internally it contains a
> FTDI FT232BM, a LCX244 and a DS89C430 micro if that's any help.
> 
> tia
> Mark

the ARM-USB-OCD and the other USB JTAGs supported by the OpenOCD or Rowley's
CrossWorks use the FT2232, and I doubt that's compatible with the MAXQ2000
JTAG.

Regards,

Dominic

Mark Harriss wrote:
> 
> 
> 
>     Hi, Can anyone advise me if I can use my Olimex USB
> MAXQ2000 JTAG programmer to program ARM microcontrollers?.
> The 10 pin connector would have to have a 20 pin adapter made
> to match up the JTAG signals correctly. Internally it contains a
> FTDI FT232BM, a LCX244 and a DS89C430 micro if that's any help.
> 
> tia
> Mark

Mark, post your message to the Olimex (Sparkfun) help forum at:
http://forum.sparkfun.com/index.php

you should get an answer there.
Don...




-- 
Don McKenzie

Site Map:            http://www.dontronics.com/sitemap
E-Mail Contact Page: http://www.dontronics.com/email
No More Damn Spam:   http://www.wizard-of-oz.com

Serial OLED uses standard micro-SD memory cards.
http://www.dontronics-shop.com/product.php?productid=16659

USB Flash Drive interface for existing products.
http://www.dontronics-shop.com/product.php?productid=16654