Hi everyone; I got 2 Axiom 68HC11 CMD11E1 boards used by other guys before. But Buffalo Monitor cannot work. I install AxIDE on windows XP. set serial port option: 9600, N, 8, 1, off, off, off. When I reset the board and press enter key , I can see the cusor _ moves forward and goes to new line, but no Message " BUFFALO 3.4AX - Axion version of the Motorola Monitor /Debugger". I check all Jumpers and power. One guy told me that I should upload buf34x.s19 to board. I set Jumper 1, 2 and 10 on and select " program EEPROM (Flash or External)" and click ok. After I reset the board, execut bootloader, the error message report "Bootloader code wasn't executed". I want configure the board, but it report the same error "Bootloader code wasn't executed". Do you think the hardware has problem? Thanks Jian |
Axiom 68HC11E1 CMD11E1 Buffalo Monitor cannot work.
Started by ●July 27, 2004