Forums

programming mc68hc11e1 EEPROM with jbug

Started by reganumah January 9, 2006
hello, i'm currently trying to program the EEPROM of a mc68hc11e1 MCU.
the JBug11 software is able to read the memory and also the registers
but i am just not able to load a s.19 file into the eeprom. Wen i go
the the File/Load s.19 MCU, the output window shows the directory but
it does not show where the codes have been saved( like it supposed
to). wen i check the memory at B600, it is emtpy. i would like to noe
where my mistake is? i hope someone could help me by giving step by
step insturuction to programming my eeprom at B600. thank you.



You did not say if you cleared BPROT before trying to load?

----- Original Message -----
From: "reganumah" <regan_83@rega...>
To: <m68HC11@m68H...>
Sent: Monday, January 09, 2006 9:21 AM
Subject: [m68HC11] programming mc68hc11e1 EEPROM with jbug > hello, i'm currently trying to program the EEPROM of a mc68hc11e1 MCU.
> the JBug11 software is able to read the memory and also the registers
> but i am just not able to load a s.19 file into the eeprom. Wen i go
> the the File/Load s.19 MCU, the output window shows the directory but
> it does not show where the codes have been saved( like it supposed
> to). wen i check the memory at B600, it is emtpy. i would like to noe
> where my mistake is? i hope someone could help me by giving step by
> step insturuction to programming my eeprom at B600. thank you. >
> Yahoo! Groups Links >
>