Forums

LPC2292 Hardware

Started by dearg_dave January 12, 2006
Hi All,

I am new to this forum, new to the Philips uC, and new to ARM7. I am
designing a new product using the LPC2292. As with all new designs,
there are always those hardware "gotchas". I was wondering if anybody
has encountered them and would like to share them with me. I am
utilizing just about all the modules this chip has to offer(RS232,
RS485, CAN, I2C, SPI, on board Flash, external RAM and a couple of
external periphials).

Thanks


An Engineer's Guide to the LPC2100 Series


Dave,
Take a look at the errata.....

Brian K. Mohlman
Project Engineer (Electrical)
Advanced Concepts Design Engineering
JLG Industries Inc.
1 JLG Drive
McConnellsburg, PA 17233
Ph. (717) 485-6495
mailto:bkmohlman@bkmo...
http://www.jlg.com
http://www.gradall.com

***********************************************************************
The information contained in this transmission is confidential. It is
intended solely for the use of the individual(s) or organization(s) to
whom it is addressed. Any disclosure, copying or further distribution
is not permitted unless such privilege is explicitly granted in writing
by JLG Industries, Inc.
Further, JLG Industries, Inc. is not responsible for the proper and
complete transmission of the substance of this communication nor for
any delay in its receipt.