Forums

startup problem with ulink

Started by mucko January 19, 2006
Hi everbody!,

I am using keil-ulink development tools for my
designed lpc2138 board. I have a problem about runnig
the program: ulink works well and download the code
without any problem but after giving run command from
keil, the chip is not going to main. it executes some
assembly commands. I think this is a startup code but
how can i solve this problem. With mcb2130 board
program runs well.

please any advice?

__________________________________________________




An Engineer's Guide to the LPC2100 Series

> I am using keil-ulink development tools for my
> designed lpc2138 board. I have a problem about runnig
> the program: ulink works well and download the code
> without any problem but after giving run command from
> keil, the chip is not going to main. it executes some
> assembly commands. I think this is a startup code but
> how can i solve this problem. With mcb2130 board
> program runs well.

Debugging from RAM? If so: when debugging from RAM MEMMAP must equal 2. Joel