Trouble with the flash programming

Started by Shiraj February 23, 2006
Hi, 
I am trying to load my code into the flash of my LPC-E2294 board using
the Phillips LPC2000 flash utility. I am using 9600 baud rate, XTAL
freq 60, device LPC2294. I am getting " cannot connect to the test
board" error. I tried different COM ports, freq .. same result can
anyone please help ?
Thanks
sam
	

An Engineer's Guide to the LPC2100 Series

----- Original Message ----- 
From: "Shiraj" <shadhin99@shad...>
To: <lpc2000@lpc2...>
Sent: Thursday, February 23, 2006 5:19 AM
Subject: [lpc2000] Trouble with the flash programming
	> Hi, 
> I am trying to load my code into the flash of my
LPC-E2294 board using
> the Phillips LPC2000 flash utility. I am using 9600 baud rate, XTAL
> freq 60, device LPC2294. I am getting " cannot connect to the test
> board" error. I tried different COM ports, freq .. same result can
> anyone please help ?

Crystal frequency = 60????

Leon