Forums

Interface of Olimex JTAG Cable in IAR

Started by Bansi Pawar May 20, 2006
Hi all,
I have tried to configure OLIMEX JTAG cable with my LPC2106 board, but
when I run debug mode from IAR IDE(free download version), it responds
with "JTAG Cable not connected". Does this cable support to LPC2106 and
IAR compiler?

Thanks in advance

--Bansi





An Engineer's Guide to the LPC2100 Series

hi, Olimex ARM-JTAG works well with IAR via H-JTAG. You may follow
the steps below for the configuration.

1. The H-JTAG freeware could be downloaded from
http://hjtag.blogspot.com/.

2. In H-JTAG "Settings" menu, configure the "Jtag settings" as shown
in the picture http://www.olimex.com/dev/images/H-JTAG.gif.

3. Use H-JTAG "Detect target" to check whether the connection btw
the host and target board is working properly.

4. In IAR->Project->Options->Debugger, choose RDI as driver.

5. In IAR->Project->Options->Debugger->RDI, enter the H-JTAG.dll to
the RDI driver.

6. Press CTRL+D to start IAR debugging mode.

Hope this helps.

Regards,
Tim.
http://www.embeddedhub.com/

--- In l..., "Bansi Pawar" wrote:
>
> Hi all,
> I have tried to configure OLIMEX JTAG cable with my LPC2106 board,
but
> when I run debug mode from IAR IDE(free download version), it
responds
> with "JTAG Cable not connected". Does this cable support to
LPC2106 and
> IAR compiler?
>
> Thanks in advance
>
> --Bansi
>