OLIMEX LPC2294 help..

Started by suyash June 28, 2006
hi all,

I am working on olimex E2294 board under GNU GCC environment.
but the code which I had written for IO toggling is not working on the
board.
I am using eclipse IDE for it, In this same the target gets build
there and also runs fine in debugger-mode(JTAG) but somehow its not
working on the actual hardware.

I also couldn't fond any sample test code on olimex's website for
LPC E2294 using GNU arm toolchain.

so can sombody provid any sample test code, for E2294.

regards.
Suyash.

An Engineer's Guide to the LPC2100 Series