ET-Base Serial Bootloader

Started by petehighdesert March 5, 2007
I bought a ET-Base ARM7 LPC2103 and was developing an app using the
serial bootloader to flash it. At some point the device went into
continuous reset. I think this because I output a string to the
serial port at system start. I see that message over and over. When
I hit the load and reset button the bootloader is not invoked, so I
can't reprogram it via the serial bootloader. I have since bought a
wiggler, but can't get that to work either. Is there anyway to
program this device?

An Engineer's Guide to the LPC2100 Series