Forums

JTAG Debugging of lpc2106

Started by bwende1 June 20, 2004
Hallo

Im searching for any tutorials or help for JTAG debugging of the
lpc2106.

I heard that there are some problems with JTAG flash-programming!?
Is it possible to program the flash or the ram with the JTAG-Adpater?

I got the Olimex LPC-P1 Board and the ARM-JTAG for Parallel-Port also
from Olimex. Thanks for any help...



An Engineer's Guide to the LPC2100 Series

----- Original Message -----
From: "bwende1" <>
To: <>
Sent: Sunday, June 20, 2004 6:21 PM
Subject: [lpc2000] JTAG Debugging of lpc2106 > Hallo
>
> Im searching for any tutorials or help for JTAG debugging of the
> lpc2106.
>
> I heard that there are some problems with JTAG flash-programming!?
> Is it possible to program the flash or the ram with the JTAG-Adpater?
>
> I got the Olimex LPC-P1 Board and the ARM-JTAG for Parallel-Port also
> from Olimex.

It depends on the tools you are using. Both RAM and Flash debugging are
available with the CrossWorks tools, at any rate, and both may be
programmed, of course.

Leon

Leon




> It depends on the tools you are using.

I use the Gnuarm toolchain. I would prefer free tools for
debugging/programming.

Benjamin