CrossWorks Debugger loosing breakpoints?

Started by Markus Zingg May 10, 2008
Hi Group

When I debug in CrossWorks (Release 1.7 build 6) I often loose all the
two hardware breakpoints. With "loose the breackpoints" I mean that even
though NO breakpoints (or only one) is set, CrossWorks tells me that no
more breakpoints are available.

It most often happens when I either hit a breakpoint that was set and
then try to singlestep (even though only ONE breakpoint is used) or if I
use previousely the "run to" (with no other breakpoint set) and then try
to continue.

Is this a bug or am I doing something wrong? Does it eventually relate
to the JTAG dongle I'm using (AmonTec JTAG tiny in my case).

TIA

Markus

An Engineer's Guide to the LPC2100 Series

Hi Markus,

Could you give the latest build a try.

Thanks
Michael

>
> Hi Group
>
> When I debug in CrossWorks (Release 1.7 build 6) I often loose all the
> two hardware breakpoints. With "loose the breackpoints" I mean that
even
> though NO breakpoints (or only one) is set, CrossWorks tells me that no
> more breakpoints are available.
>
> It most often happens when I either hit a breakpoint that was set and
> then try to singlestep (even though only ONE breakpoint is used) or
if I
> use previousely the "run to" (with no other breakpoint set) and then
try
> to continue.
>
> Is this a bug or am I doing something wrong? Does it eventually relate
> to the JTAG dongle I'm using (AmonTec JTAG tiny in my case).
>
> TIA
>
> Markus
>