Forums

Delay after Re-Enabling interrupts

Started by Unknown September 16, 2004
Hello,

I'm working with IAP and as recommended by the LPC2119 manual I'm
disabling all the interrupts I use (TIMER0 and CAN1 Rx) before any
erase or write operation on the Flash.

Everything's working fine, the only "problem" is that sometimes it
takes some time(~20-30sec.) for the interrupts to wake up the first
time I disable them.

This is the process the 1st time I disable interrupts:
1.- Disable Interrupts
2.- Erase sectors (1..14)
3.- Enable Interrupts
4.- Send CAN Message
.........delay here........
5.- Receive CAN Message

I know the delay is not while erasing sectors because I actually see
that my CAN msg it's received... but I can't detect any CAN msg sent
to me until that ~20-30sec.

A few steps ahead I disable/enable the ints. to program the Flash,
and this time it all works without any delay.

Does anyone have any idea of what might be happening?

Thanks in advance,
Gonzalo


An Engineer's Guide to the LPC2100 Series