Auto Flow Control @ Uart1 in LPC2368

Started by tayyaba_ch June 4, 2008
Hi
I am using LPC 2368 ad using auto flow control to communicate with
another LPC2368 @ Uart1,i am using 8 byte RX trigger level @ both
ends.i checked with oscilloscope ,data is not transferred when rts1 is
high.but still i am not getting whole data ...data is missing and
corrupt some time.

Anybody who ever worked with uart1 , auto flow control enabled.

Regards

An Engineer's Guide to the LPC2100 Series

--- In l..., "tayyaba_ch" wrote:
>
> Hi
> I am using LPC 2368 ad using auto flow control to communicate with
> another LPC2368 @ Uart1,i am using 8 byte RX trigger level @ both
> ends.i checked with oscilloscope ,data is not transferred when rts1 is
> high.but still i am not getting whole data ...data is missing and
> corrupt some time.
>
> Anybody who ever worked with uart1 , auto flow control enabled.
>
> Regards
>
I am Done ....there was some problem with my UART Library....