about IAR

Started by sukhdeep singh January 13, 2009
hi,    i am new to do programming of LPC2378 in IAR ARM compiler. how can i do programming in IAR. i have wriiten the code in IAR compiler but it does not run on hardware, when i burn it into the LPC2378.kindly help me.thanks
Add more friends to your messenger and enjoy! Go to http://messenger.yahoo.com/invite/


An Engineer's Guide to the LPC2100 Series

Did you try a simple known working code example?

Does the target hardware working ?

_____

From: l... [mailto:l...] On Behalf Of
sukhdeep singh
Sent: 13 January 2009 09:21
To: NXP
Subject: [lpc2000] about IAR

hi, i am new to do programming of LPC2378 in IAR ARM compiler. how can i
do programming in IAR. i have wriiten the code in IAR compiler but it does
not run on hardware, when i burn it into the LPC2378.kindly help me.thanks

Add more friends to your messenger and enjoy! Go to http://messenger.
yahoo.com/invite/




sukhdeep singh schrieb:
> hi, i am new to do programming of LPC2378 in IAR ARM compiler. how can i do programming in IAR. i have wriiten the code in IAR compiler but it does not run on hardware, when i burn it into the LPC2378.kindly help me.thanks

IAR has 3 2378 examples, try one of these and start learning how to debug.
--
42Bastian

Note: SPAM-only account, direct mail to bs42@...

hi,    when i start to burn the example code. then programmer software gives the message
RAM locations 0x40000120 to 0x400001ff are used by bootloader.please ensure the these locations are not used by firmware.how can i solve the problem.second thing, is it neccessory to include cstartup file in making project code for C or there is another method to solve the problem.thankssukhdeep singh













Add more friends to your messenger and enjoy! Go to http://messenger.yahoo.com/invite/


sukhdeep singh schrieb:
> hi, when i start to burn the example code. then programmer software gives the message
> RAM locations 0x40000120 to 0x400001ff are used by bootloader.please ensure the these locations are not used by firmware.how can i solve the problem.second thing, is it neccessory to include cstartup file in making project code for C or there is another method to solve the problem.thankssukhdeep singh

Read the linker-manual.
--
42Bastian

Note: SPAM-only account, direct mail to bs42@...