Forums

LPC2294 IO Ports

Started by jdauchot March 23, 2009
Hi

I am trying to use P0.27 to P0.30 as outputs on an LPC-L2294 Dev Board.
I do not have any success in toggling those port. Is there any registers I need to setup apart from direction etc.

I look in the manual and those ports are part of the hadware debug

Regards

Jean-Jacques

An Engineer's Guide to the LPC2100 Series

Hi

I fix it, those pins are set to AIN0 to AIN3 on reset.
Bommer

Regards

Jean-Jacques
--- In l..., "jdauchot" wrote:
>
> Hi
>
> I am trying to use P0.27 to P0.30 as outputs on an LPC-L2294 Dev Board.
> I do not have any success in toggling those port. Is there any registers I need to setup apart from direction etc.
>
> I look in the manual and those ports are part of the hadware debug
>
> Regards
>
> Jean-Jacques
>