HI~
I am using IARWB v4.2 developing IAP on LPC2148.
I read the user manual and got the specific discription of how to use IAP
functions. But when I began to do that programming in the IAR workbench
following the user manual, I found that it was not working.
Somebody told me that I should set configuration for the *.xcl file. But
I really have no clue how to make that configured. Could somebody give me some
introductions about how to make that done using IAR WB?
Any replies will be appreciated~
Jean
Questions about IAP work with IAR workbench on LPC2148
Started by ●December 1, 2009
Reply by ●December 1, 20092009-12-01
the .XCL won't affect your ability to do IAP. It's used by the linker
for mapping your code.
--- In l..., "jiaomj" wrote:
>
> HI~
> I am using IARWB v4.2 developing IAP on LPC2148.
> I read the user manual and got the specific discription of how to use IAP functions. But when I began to do that programming in the IAR workbench following the user manual, I found that it was not working.
> Somebody told me that I should set configuration for the *.xcl file. But
> I really have no clue how to make that configured. Could somebody give me some introductions about how to make that done using IAR WB?
>
> Any replies will be appreciated~
>
> Jean
>
--- In l..., "jiaomj" wrote:
>
> HI~
> I am using IARWB v4.2 developing IAP on LPC2148.
> I read the user manual and got the specific discription of how to use IAP functions. But when I began to do that programming in the IAR workbench following the user manual, I found that it was not working.
> Somebody told me that I should set configuration for the *.xcl file. But
> I really have no clue how to make that configured. Could somebody give me some introductions about how to make that done using IAR WB?
>
> Any replies will be appreciated~
>
> Jean
>
