Forums

lpc2214 hang up

Started by afer...@eurotektel.com December 1, 2009
Hello everybody,

I'm working on LPC2214 and after a hardware reset it's gone in a hang up state.... my micro doesn't execute the correct code, also after a new hardware reset.

Only after a power down and following power up the lpc2214 has come to work correctly.

I suspect of the RTCK pin because I had this pin low during the reset and in this case the pin p1.26-p1.31 could be used like debug port; does anyone know something about this issue?

Thanks in advance

Alberto Ferrari

An Engineer's Guide to the LPC2100 Series