LPC2388 - MCB2300 - Ethernet Bootloader

Started by Carolina March 21, 2011
Hello everyone,

I am trying to use the Ethernet bootloader from the NXP website and the bootloader itself works, but for some reason when I want to load (using the ethernet bootloader)the blinky.c program that is also given along with the bootloader project I cannot get it to work and in the RS232 debug window I get this message "Frame from different MAC: Filtered out!" and then flash magic tells me that it is "Unable to communicate. (handshake failed) Check internet interface is working". Any ideas why?

Carolina

An Engineer's Guide to the LPC2100 Series