Forums

Re: Atmel dataflash

Started by md23ch June 16, 2012
Dear Experts,

I have the LPC1768 base board equipped with the AT45DBxxxx.
Do you have some code example how to deal with the data flash.
I will appreciate it very much.

Thank you in advance

md23ch

--- In l..., "Tim Mitchell" wrote:
>
> Hardware SSEL pin is for when the LPC is an SPI slave.
> It isn't used when LPC is an SPI master, just use GPIO as the others have said.
>
> --
> Tim Mitchell
>
>
>

An Engineer's Guide to the LPC2100 Series

--- In l..., "md23ch" wrote:
>
> Dear Experts,
>
> I have the LPC1768 base board equipped with the AT45DBxxxx.
> Do you have some code example how to deal with the data flash.
> I will appreciate it very much.
>
> Thank you in advance
>
> md23ch
I would start with this document:
http://www.atmel.com/Images/doc0842.pdf

Richard

> I would start with this document:
> http://www.atmel.com/Images/doc0842.pdf
>
> Richard
>

Thanks for the link. I have checked this document already.
I have asked for the code example in order not to reinvent the wheel.

md23ch

>
> Thanks for the link. I have checked this document already.
> I have asked for the code example in order not to reinvent the wheel.
>

You can download the source code for the drivers for the Atmel dataflash and other devices on the Embedded Artists LPCxpresso Base Board from their product support site:

http://www.embeddedartists.com/support/overview

Regards,
Chris Burrows

Astrobe v4.2: Oberon for Cortex-M3 Development System
http://www.astrobe.com