Re: problem with crossworks

Started by Michael Johnson March 21, 2005
Have you tried any of the standard CrossWorks examples?

Regards
Michael

>I am now getting acquainted with the crossworks compiler and lpc2104.I
>built my own board and downloaded the programs given in this forum as
>starting point.But the hex file created after compiling the code does
>not run.The program is to toggle a pin (blink_ADS_1.2) given in file
>section.What is wrong since a sample program using winarm ran
>perfectly.Can somebody suggest any solutions.Thanx >
>
>Yahoo! Groups Links >




An Engineer's Guide to the LPC2100 Series


I am now getting acquainted with the crossworks compiler and lpc2104.I
built my own board and downloaded the programs given in this forum as
starting point.But the hex file created after compiling the code does
not run.The program is to toggle a pin (blink_ADS_1.2) given in file
section.What is wrong since a sample program using winarm ran
perfectly.Can somebody suggest any solutions.Thanx



That is good advice. Crossworks comes with the best set of examples I
have seen. It would not be difficult to modify one to your hardware.

Richard

--- In , Michael Johnson <mpj@r...> wrote:
> Have you tried any of the standard CrossWorks examples?
>
> Regards
> Michael
>
> >I am now getting acquainted with the crossworks compiler and lpc2104.I
> >built my own board and downloaded the programs given in this forum as
> >starting point.But the hex file created after compiling the code does
> >not run.The program is to toggle a pin (blink_ADS_1.2) given in file
> >section.What is wrong since a sample program using winarm ran
> >perfectly.Can somebody suggest any solutions.Thanx
> >
> >
> >
> >
> >
> >
> >
> >Yahoo! Groups Links
> >
> >
> >
> >
> >
> >
> >
> >
> >