Forums

IAP with UART

Started by sig5534 August 30, 2005
I want to be able to update our LPC2104 firmware with a UART
interface. It seems like the UART is setup to rely on INTs for
transfer. Given that the code must be executed in RAM, I suppose the
INTs for the UART must be setup in RAM as well.

Are there any example files around of this kind of RAM code setup for
moving the INTs into RAM. I see it talked about all the time in the
lit but have not seen any code examples.

Or the easier way might be to run the UART without the need of INTs.
Anyone done any of this?

Thanks, Chris.


An Engineer's Guide to the LPC2100 Series