Forums

Can IAR Embedded Workbench 4.0 be used using PC Parallel Port?

Started by "sachin .b . rathod" February 14, 2007
Hello,

Can IAR Embedded Workbench 4.0 be used without TI USB TET or not??

I have made the ready made hardware of MSP430-JTAG which can be programmed through PC parallel port. In the IAR, it is given in
Project---->settings----> LPT1.

So is this has been written only for TI USB FET or it is also for PC parallel port??

In short, can we use IAR Embedded Workbench 4.0 for programming MSP430-JTAG using PC parallel port??

Please help me , i m in trouble now.

Regards,
Sachin.

---------------------------------
Heres a new way to find what you're looking for - Yahoo! Answers

Beginning Microcontrollers with the MSP430

All tools can use the TI FET on LPT for program/debug, including IAR.
Best is to use it on the standard 14 pin JTAG connector, other side on LPTx
You might have to adjust your LPT settings in BIOS if you have trouble ie. ECP/EPP etc.
but it should work straight away. (IIRC I used ECP, long time ago)

Best Regards,
Kris

-----Original Message-----
From: m... [mailto:m...] On Behalf Of sachin .b . rathod
Sent: Wednesday, 14 February 2007 9:32 PM
To: m...
Subject: [msp430] Can IAR Embedded Workbench 4.0 be used using PC Parallel Port?

Hello,

Can IAR Embedded Workbench 4.0 be used without TI USB TET or not??

I have made the ready made hardware of MSP430-JTAG which can be programmed through PC parallel
port. In the IAR, it is given in
Project---->settings----> LPT1.

So is this has been written only for TI USB FET or it is also for PC parallel port??

In short, can we use IAR Embedded Workbench 4.0 for programming MSP430-JTAG using PC parallel
port??

Please help me , i m in trouble now.

Regards,
Sachin.

---------------------------------
Here's a new way to find what you're looking for - Yahoo! Answers



Yahoo! Groups Links