RE:Solution] IAR Unable to download release version via jtag
Started by ●August 20, 2014
Speaking of IAR, I run their MSP430 assembler. But it is an older version that
does not support the 20 bit addresses. Any suggestions were I can get an update
on this?
Reply by ●August 20, 20142014-08-20
Original message:Speaking of IAR, I run their MSP430 assembler. But it is an
older version that does not support the 20 bit addresses. Any suggestions were
I can get an update on this?
Okay, we get lazy. After using a tool forever, we forget that there is documentation that comes along with it. Good news is, I did update my assembler and linker to version 6.10 and 6.0 from something in the 4.0 range.
The answer to the question is the -v option.
Using -v0 uses the MSP430 native instructions
Using -v1 uses the MSP430X instruction set.
Blakely
--
Blakely LaCroix
Minneapolis, Minnesota, USA
Okay, we get lazy. After using a tool forever, we forget that there is documentation that comes along with it. Good news is, I did update my assembler and linker to version 6.10 and 6.0 from something in the 4.0 range.
The answer to the question is the -v option.
Using -v0 uses the MSP430 native instructions
Using -v1 uses the MSP430X instruction set.
Blakely
--
Blakely LaCroix
Minneapolis, Minnesota, USA
Reply by ●August 20, 20142014-08-20