Convert program code from 16F84 to 16F628??

Started by Shawn McClintock December 4, 2003

How hard would it be to port a program written for the 16F84 to a
16F628? Any big changes need made? Or can I just recompile with new
processor selection and appropriate changes in code for device type?

Shawn



Check these sites for your answer:
http://www.dontronics.com/cat_hard_micro_pic.html#628spec
http://www.finitesite.com/d3jsys/16F628.html
Rick C.

Shawn McClintock wrote:

 
How hard would it be to port a program written for the 16F84 to a
16F628? Any big changes need made? Or can I just recompile with new
processor selection and appropriate changes in code for device type?

Shawn




Message
Thanks Rick,
    Since my program is in C I should be fine, the compiler should take note of the minor differences and put it together appropriately.
Thanks for the info!
Shawn
 
-----Original Message-----
From: Rick C. [mailto:r...@Vvalley.com]
Sent: Thursday, December 04, 2003 6:23 AM
To: p...@yahoogroups.com
Subject: Re: [piclist] Convert program code from 16F84 to 16F628??

Check these sites for your answer:
http://www.dontronics.com/cat_hard_micro_pic.html#628spec
http://www.finitesite.com/d3jsys/16F628.html
Rick C.

Shawn McClintock wrote:


How hard would it be to port a program written for the 16F84 to a
16F628? Any big changes need made? Or can I just recompile with new
processor selection and appropriate changes in code for device type?

Shawn



to unsubscribe, go to http://www.yahoogroups.com and follow the instructions

">Yahoo! Terms of Service.