Bumblebee software.

Started by Eugene S. Gopalan March 8, 2004
Anyone using bumblebee with their Wisp628?
When using it to program devices, I keep getting the message "error
processing command w"
This happens after it goes through the programming sequence. The device
doesn't run.
I have no idea what is wrong.

Target board, device (16F877A) & wisp 628 are all ok as it can be programmed
with Xwisp.

Yes, I know I could use Xwisp, but I kinda like the Bumblebee user interface
(sorry Wouter) Regards,

Eugene



> When using it to program devices, I keep getting the message "error
> processing command w"

Could that be at address 2007? In that case you should compare the fuses
value you sp[ecify against the 'fixed bits' documented in the datasheet.
The programmer does not know about these, so when you say "1" and the
bit is fixed at "0" it will report an error. This has to be fixed in the
PC software.

> Yes, I know I could use Xwisp, but I kinda like the Bumblebee
> user interface (sorry Wouter)

No offense at all. But you could try XWisp to see whether it makes any
difference.

Wouter van Ooijen

-- -------
Van Ooijen Technische Informatica: www.voti.nl
consultancy, development, PICmicro products