Re: Ask for PICBlaster

Started by taufiq_tqr July 16, 2004
Dear,
I will ask for this mailist about PICBlaster. I have make
PICBlaster hardware and using software ICProg for running programming
PIC16F84A but I finding error message "Failed at Address 0000H".
Please give me answer about this problem. I use PC Intel P4 with OS
Windows XP Prof. Thanx.



Ok, 1 definite and 1 possible problem I see:

1 definite problem: software is not NT/XP compatible

2 possible problem: hardware requires rs232 output
voltages of about 12 volt the rs232 spec defines these
as a lot lower to a little higher so even if your
rs232 port is within spec 3 to 15 volt signals
positive and negative, they may not be high enough for
this programmer

Peter van Hoof --- taufiq_tqr <> wrote:
> Dear,
> I will ask for this mailist about PICBlaster. I
> have make
> PICBlaster hardware and using software ICProg for
> running programming
> PIC16F84A but I finding error message "Failed at
> Address 0000H".
> Please give me answer about this problem. I use PC
> Intel P4 with OS
> Windows XP Prof. Thanx. >

__________________________________