16F628

In a message dated 11/20/2004 2:37:22 AM Eastern Standard Time, j...@yahoo.com writes:

Hello. I'm using PicBasic Pro and a PIC16F628. I've been reading up on the DEBUG command, and can't seem to get it to work. I am using Hyper Terminal

P.S.  If you have trouble with Hyper, you can use the Stamp debug screen.  It works just as well.

Sid

to unsubscribe, go to http://www.yahoogroups.com and follow the instructions

Can it be done with either a F84A, F628, or F628A?

Even more useful would be to use a 12F629 or F675.

 

I preffer not to have a 40-Pin DIP in my design due to space constraints.

 

Thank you,

John Baker

N...@aol.com wrote:

In a message dated 11/20/2004 10:54:10 AM Eastern Standard Time, j...@yahoo.com writes:

I'm having no luck with this. Do I need to connect more than pin2 and ground on the DB9?

Yes - DB9.2 to C.6 via a 470 ohm resistor, DB9.3 to C.7 via a  22K resistor.  These are the hardware USART pins, which means true mode.  Delete your debug defines - use C.6 for so, C.7 for si.  Use baud = 84.

Can you do this?  If not, what chip are you using?

Sid

to unsubscribe, go to http://www.yahoogroups.com and follow the instructions

---