No profile info found for aruntkkumar

MSP430 is little endian. The INTVEC section is going to the correct address FFC0-FFFF (64 bytes). Is there a way if the memory locations of the statements DW jumpvecX...
It seems when I change the memory size to 64K, the INTVEC defined under .hzx is shown as below:CODE SECTION INTVEC [LOAD=YES]          dw      jumpvec0 ...
The current bootloader that I am working on for MSP430F2618 works fine with memory size of 64K and instruction set of MSP430X. Changing the memory size to 1MB does...

Use this form to contact aruntkkumar

Before you can contact a member of the *Related Sites:

  • You must be logged in (register here)
  • You must confirm you email address