(@pankajpatro703)
Thanks for replying @CustomSarge.Alas, the sensors can only communicate using RS485, so using RF would again require me to use converters. Not to mention the interference...
Thanks @matthewbarr.There will be more than one sensor, so there will be a multi drop. The low data rate is fine.About the converters, I just wanted to know which...
I need to connect multiple sensors to the main controller, so if I were to go adding controllers to each sensor, the cost increases.
@Kocsonya, thanks for replying. I need to connect sensors that communicate on RS485 to the microcontroller. The distance can go low upto 250m in most cases.
Use this form to contact pankajpatro703
Before you can contact a member of the *Related Sites:
- You must be logged in (register here)
- You must confirm you email address
