Sign in
Search rabbit-semi
Subscribe to rabbit-semi
Discussion Groups
Rabbit-Semi
This is a group for folks designing and programming embedded systems using the Rabbit Semiconductor C-programmable microcontroller. Rabbit Semi is a spin-off from Z-World who makes a variety of embedded modules and tools. This group is not affiliated with either Rabbit or Z-World, but is a user forum for sharing ideas, asking questions, flaunting knowledge, and other typical user group stuff. The Rabbit is a powerful uC, supported by a full-featured C-compiler.
A question about float to int casting.
Julian Higgison - May 26 2008
Hi all!
I'm kinda new here, but have been lurking for a while and mucking about on
and off with other people's rabbit code for a bit... adding extra
features/options here and ... 
Cannot add watches dynamic c 9.21
Omar - May 26 2008
Hello
I have a long program into my RCM3700 (3100 lines of codes).
In Adition i have a lonf sprinf statment (416 characters long).
Are this the cause for cannot add watches ? ... OP7200 [2 Articles]
pablo_aguilar_99 - May 25 2008
Hello,
I have been using an OP7200 with an RCM2200, but unfortunately, I am
running out of memory for my application, there is any other
microprocessor that I can replace the ... pwm_init [2 Articles]
Antonio Parziale - May 24 2008
hi to everyone,
i'm using pwm_init() function for setting frequence of a PWM signal created by a RCM3700
i wrote:
main()
{
unsigned long freq;
freq = pwm_init(xxx);
... using anainvolts and pwm simultaneously
Marinelle - May 24 2008
Hi, I would like to drive my motors using pwm and read voltage input
using anavolts from my IR sensor.
I am using rabbit 4000 and rcm 4100.
My problem is, when pwm is runn... Reserving specific addresses in battery backed RAM (RCM3365) [4 Articles]
pdaderko - May 24 2008
Hey,
I've got an RCM3365 module that I'm logging data to the flash. I'm
keeping an index of the log in the battery backed RAM so after a reset
I still know where everything i... Re: why can't I use anaInVolts and pwmOutVolts at the same time
Marinelle - May 24 2008
Hi Antonio,
I am running to the same problem as you are. How were you able to
resolve using pwm and anainvolts simultaneously?
Thanks!
Marinelle
--- In r...@yahoogroups.... reading data from a pulldown menu in a form [2 Articles]
Ilya Chigirev - May 22 2008
I'm really new at this and this is probably something a lot easier
than what i am making out to be but does anyone know how to read the
value of the selection in a pull down menu... Help on simple clocked serial operations
Marco Trapanese - May 22 2008
Hello,
I'm using an RCM4100 which should communicate with an external device
through a clocked-serial port (CS, MISO, MOSI, SCK). The RCM is the
Master, the other device the S... RCM4100, ADC and I/O pin
Marco Trapanese - May 22 2008
Hello,
I have a big doubt. Better, I hope I misunderstand the situation
because I didn't find any notes on this in the documentation.
I have an RCM4100 with the ADC ADS7870 ...