Stepper motor control usig HC12

Hi, everyone!

Has somebody had any experience with stepper motor control using HC12
uC?

Any hint or issue about it would be very helpful.

Thanks a lot

Fabio

Start a New Thread

Peace on you;

the AN2974
http://www.freescale.com/files/microcontrollers/doc/app_note/AN2974.pdf
app note from freescale describes how to drive a stepper motor.

Hope it helps !

Hesham
On 6/30/06, fhgrossi wrote:
>
> Hi, everyone!
>
> Has somebody had any experience with stepper motor control using HC12
> uC?
>
> Any hint or issue about it would be very helpful.
>
> Thanks a lot
>
> Fabio
>
>
>

--
Hesham Shokry
Software Engineer
Cell : +2 (0) 10 5199764
E-mail : h...@eg.ibm.com

Cairo TDC ( Technology Development Center ), CMMi L5
IBM World trade Corporation, Egypt Branch
P.O. Box 166 El-Ahram, Giza ,Egypt
Pyramids Heights Office Park, Building C9,
Cairo - Alexandria Desert Road, Km. 22,
Giza, Egypt
Switch Board: +202 536 2536 Ext. 1811
Direct : +202 536 1811
Fax: +202 536 2505
Sametime : h...@eg.ibm.com
Working days: Sun – Thurs. Time zone: GMT+2:00
---------------------------
You can get it RIGHT, or you can get it NOW...
But you can not get It RIGHT NOW






Start a New Thread