Hi all, I've got an issue. My ICD-2 on MPLAB 6.60 says that the programmer won't support the 16F628. The MC website says it will program it, but not debug it without an adapter. OK, since my IDE refuses to let me choose the ICD-2 as my programmer, it is obvious which way the wind blows. Can anyone else get this combination to work? Do I have to set some flag or twiddle some bit for this to do as the web site says? Thanks for any help, DLC |
|
ICD 2 support for 16F628?
Started by ●September 27, 2004
Reply by ●September 27, 20042004-09-27
you sure it supports the 628? I thought it supported the 628A but not the non-A part. --- In , "Dennis Clark" <dlc@f...> wrote: > Hi all, > > I've got an issue. My ICD-2 on MPLAB 6.60 says that the programmer > won't support the 16F628. The MC website says it will program it, but > not debug it without an adapter. OK, since my IDE refuses to let me > choose the ICD-2 as my programmer, it is obvious which way the wind > blows. > Can anyone else get this combination to work? Do I have to set > some flag or twiddle some bit for this to do as the web site says? > > Thanks for any help, > DLC |
Reply by ●September 28, 20042004-09-28
Hi,
I have the same problem Whitch ICD2 and 16F628.
I use the ICD2 for debugger. And any PIC's have ICD suppurt. 16F628
have not ICD suport. But 16F628A have support. you can use it for debug.
For Programing Chip use a Programmer. I use Micropro PIC Programmer
(Diyk149B kit).
I have make it by myself and it work perfect.
Hasan Arslan
MCU Designer
Dennis Clark <d...@frii.com> wrote: Hi all,
Gesendet von Yahoo! Mail - Jetzt mit 100MB kostenlosem Speicher |