AT91SAM9260 SAMBA2.9 Ubuntu8.4
1)I am working with the ARM board mentioned above. I have crosscompiled a kernel
and now I want to flash the board with SAMBA. So I connected the board over the RS232 and the USB_D interface to my host system (Ubuntu) powerd up the board and start SAMBA. I choose the USB0 for interface and now appears the fist problem.
- Only the board AT91SAM9260 EK is available
When I choose this board with the additional EK and try to connect the following Error appears:
No valid processor ID found
How can I solve this problem? Is there a patch or something like that to add the board I'm using to the ones listed?
So the only opportunity for me to go on is to choose "no board". Then SAMBA starts.
Is it ok to flash the board choosing "no board", or is SAMBA working with wrong parameters going this way?
2) Another problem comes up when I try to communicate with minicom to the board. I start minicom with the right parameters and power up the board. It boots and after some time it's asking for an password or login. Here the text from the command terminal:
DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 7
No DHCPOFFERS received.
Trying recorded lease 192.168.0.220
PING 192.168.0.1 (192.168.0.1) 56(84) bytes of data.
--- 192.168.0.1 ping statistics ---
1 packets transmitted, 0 received, +1 errors, 100% packet loss, time 0ms
No working leases in persistent database - sleeping.
Starting portmap daemon....
INIT: Entering runlevel: 2
Starting system log daemon: syslogd.
Starting kernel log daemon: klogd.
Starting portmap daemon...Already running..
Starting MTA: exim4.
Starting internet superserver: inetd.
Starting OpenBSD Secure Shell server: sshd.
Starting NFS common utilities: statd.
Starting deferred execution scheduler: atdStarting periodic command scheduler: .
Debian GNU/Linux 4.0 sam9-l9260 ttyS0
There is a passwd in the manual 'olimex'. When I type the command the terminal doesn't react.
There is no error message and no login. Do anyone know what to do here?
Stud Five wrote:
> When I choose this board with the additional EK and try to connect
> the following Error appears:
> No valid processor ID found
When the processor starts up, it needs to be in the "ROM Boot" prompt.
You generally do this by disconnecting external flash, and there's a
jumper to do this. I don't know what that jumper is on the 9260, but
the manual should say.
Make sure that on the serial port you see
> sam9-l9260 login:
> There is a passwd in the manual 'olimex'. When I type the command
> the terminal doesn't react. There is no error message and no login.
> Do anyone know what to do here?
The user name you're looking for is probably "root", then try 'olimex'
or a blank password.